Skip to content
Instagram Twitter as well YouTube

SculptureBlog

by Koen van Velzen, sculptor in stone and bronze

  • Home
  • About the Sculpture Workshop
  • About Koen
  • Posts overview
  • Projects
  • Videos
  • Contact
Facebook Twitter as well Instagram
SculptureBlog
by Koen van Velzen, sculptor in stone and bronze
Eusebius | Restoration | video

Flying buttress figurine: Caritas, love

ByKoen van Velzen 17-10-202012-02-2026
copying the flying buttress statue Caritas for the Eusebius Church in Arnhem
the figurine Caritas during copying

Caritas under pressure

Gloomy clouds gather around Arnhem's Eusebius Church. After years of smooth and energetic restoration, the first restoration budget has come to its end. In a previous message from 2016 I could report that money had finally been released, and although the subsidies have been handled very efficiently, at that time it was already known that it would not be enough to complete the entire project. There is a lot of fuss in the media about it, and immediately there are also people who claim that the entire project would be a bottomless pit, but they talk like a headless chicken.

A top-class restoration

For this budget, the Eusebius Church, at less than one-third of the amount previously estimated, is being thoroughly restored and also adapted to contemporary requirements. The time of mass church attendance is simply behind us, and the church is now mainly used for other purposes. In addition, this is a top-class restoration, which can be seen by everyone who gets the chance to wander through the building and over the scaffolding. Certainly not a bottomless pit, butan examplary project. It would be foolish to stop now, just when we are nearing the finish line and have stayed within budget despite extensions to the original restoration approach. So I look forward with confidence to the next round of investment in this important building.

In the Gelderlander of 6 October 2020 the following article could be read:

Restoration Eusebiuskerk stopped again; shortage of 3 million euros

scaffolding visit Eusebius flying buttresses
The scaffolding around the tower of the Eusebius Church in 2016

ARNHEM – The restoration of the Eusebius Church in Arnhem has been halted again due to lack of money. In 2016 the work has also been stopped once, because there were no subsidies from the various governments.

There is still approximately missing 3 million euros for the completion of the last phase of the large-scale restoration project on this national monument. The hope is that the province of Gelderland will help financially in the short term.

This provincial support had already been counted on, but due to various circumstances it has not yet been granted.

Within the budget

The money is needed for the repairs to the choir part of the building. That is the part on the east side of the church, opposite the 'Duivelshuis' the Devil's House. The total restoration project for the Eusebius Church in 2013 was budgeted at approx 32,5 million euros. The total project remains within budget.

The Provincial Executive of Gelderland recently proposed to the Provincial Council to make a maximum subsidy available of 2,5 million euros to the Eusebius Arnhem Foundation, which is responsible for the preservation and operation of this house of God.

But it is not until November that the Provincial Council will decide whether to agree to this during the discussion of the budget for next year.

-Read the entire article here ↑

Two more articles: the first about the mystery of the budget deficit ↑ and the second on the period of waiting for more money↑.

The tenor of these two articles is the same: lots of alarm and drama, while there is actually not much going on. An awful lot has been done with the available money and the restoration will also be completed with the same care.

Consequences for the sculptors?

Copy flying buttress figurine de Hoop (Spes)
copying flying buttress statue The Hope at 35 degrees Celsius

Actually, this does and doesn't have consequences for us. On the one hand, we just keep doing our thing and we still squeeze out one flying buttress figurine after another. On the other hand, the budget has also been temporarily suspended for us. Why then do we just continue with those statues, you may ask?  This has everything to do with a period of relative calm before a great hustle and bustle.

Lots of work to come

The old flying buttress statue The Hope made of tuff stone
The old flying buttress statue of The Hope, out of tuff stone

I can't say everything about it yet, but in spite of the apparent calm on this blog, Jelle and I in particular have been extremely busy recently. That is the reason that I couldn't keep up with writing blog articles. Indeed, I recently completed a flying buttress sculpture that depicted The Hope, from the series of the Seven Virtues, and I simply forgot to take pictures of it! Well, then it is therefore not possible to write an article about it anymore. But it is not forgotten, I will take pictures of it later at the Eusebius Church, where the figurine is stored.

A very busy autumn and winter

Things will get even crazier in the coming months, because we are currently already working on large finials for the Utrecht Dom Tower, and another major project is coming up in Veghel, I still have to tackle a number of smaller projects, my mother eagerly awaits my father's tombstone, and there are still a great number of ornaments and sculptures coming which I cannot name yet.

Seven Virtues

sculptor Stide Vos with tattered old flying buttress figurine Fides
Stide at the old flying buttress statue of Fides. This statue clearly shows why we cut these copies: they are completely full of cracks.

But around the summer period we had a somewhat quiet time. But we have not been idle! Like with the flying buttress of the Seven Sins that we had last year, there was now the flying buttress next to it, with the Seven Virtues. Jelle and I have almost finished all of them, except for the statue of Faith, that Stide is now working on.

We thought it would be smart to tackle the next flying buttress now, because we already knew there was so much work to be done later. However, they were not waiting for that at the Eusebius Church. This flying buttress is actually part of the next restoration phase and they hadn't even started on that yet. Plus that the budget was starting to run out. But with some deliberation we could move forward. If we had postponed it, it would have become much, much busier next spring!

Two griffins

modeling in clay of griffin shield
Modeling the shield for the two griffins

When some space came up this summer, Jelle and I immediately seized the opportunity to finally decisively to continue with the modeling work on this blog the two mirrored griffins, on which I already started in 2017 with a scale model. The work is in no hurry because the castle is not ready yet, but now we have been hard at work. Soon I'll post an extensive report. In any case, we made full-size clay models and cast them in plaster. On Instagram you get to see something of these activities.

Caritas, love

copy of Caritas flying buttress statue

One of the figurines I copied for arch no. 23 is Caritas, the symbol of Love. Quite appropriate for this time in the restoration of the Eusebius Church, Caritas also means Charity and Generosity.

Sculptor Eduard van Kuilenburg has carved Caritas from tuff as a young woman in a thick dress, holding a somewhat listless child in strange proportions on her lap. It has a rather small head and very broad shoulders.

completed Caritas figurine

In the copy I made a few minor adjustments to Caritas, so that the child has a bit more of a child's head. I also made the heart that was on the right side, from a flat object into a rounded shaped, pumped up heart, because luckily I had more mass in the stone at that point. It is characteristic of our approach: we largely stick to the original sculpture, in finish, dimensions and details, but we try to give some points a little more tension, which makes the figurinea bit more expressive. We also carve, just as we did with the Seven Sins, the Latin name of each virtue in the side profile. See more about this in the post about the previous flying buttress statue from this series: Temperantia.

Gallery

  • copy of Caritas flying buttress statue
  • copy of Caritas flying buttress statue in Muschelkalk limestone
  • copy of Caritas flying buttress statue in Muschelkalk limestone
  • copy of Caritas flying buttress statue in Muschelkalk limestone
  • Charity
  • copy of Caritas flying buttress statue in Muschelkalk limestone
  • copy of Caritas flying buttress statue in Muschelkalk limestone
  • modeling in clay of griffin shield
  • The old flying buttress statue The Hope made of tuff stone
  • Copy flying buttress figurine de Hoop (Spes)

To the next flying buttress image →

Beeldhouwerijblog.nl is the blog of Koen van Velzen, sculptor in stone and bronze.
Look up my website as well: beeldhouwerijvanvelzen.nl
Follow me Instagram, Twitter as well & YouTube

Report tags: #background#Ettringer tufa#Eusebius#limestone#to go#flying buttress figurine#muschelkalk#restoration#video

Similar posts

  • Disassembling tuffstone with a concrete chainsaw

  • The sculpture is already in there, you just need to take away the rest…

  • An afternoon of carving together

  • A set of corbels for the Eusebius Church

  • making pine cone in sandstone

    A pine cone for a classic garden vase

  • Ferns completed

Post navigation

previous previous
Three flying buttresses finished- a retrospect
nextContinue
Sculpture 'Surrender’ installed

Translation

Make this the default language

Archive

Subscribe to this blog by. e-mail

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Most recent posts

  • A gargoyle head for the Zegersmonument
  • Minervalaan 5: Installing
  • Minervalaan part 4: Carving the figurines in limestone
  • Prince Carnival, in blue quartzite
  • Minervalaan part 3: reconstruction
  • A gravestone with wreath
  • Minervalaan part 2: Disassembling the statues
  • Minervalaan Amsterdam, part 1
  • Lion's heads and ornaments for Herengracht 380
  • Video tour of the workshop
  • Shivalingams and Paadas, in granite and marble
  • Of Serge van Druten, two athletes and an angel
  • Two griffins with large baroque shield in sandstone
  • Garden sculpture 'Pan’ in red porphyry – completed!
  • Five gable stones for Zeeland widows
  • Working on the Dom Tower for five years!
  • Tim repairs a Bulldog and carves a Rooster
  • A directional arrow in a large basalt boulder…can you do that???
  • Update after two years: five coats of arms
  • A large gargoyle for the Dom Tower

Featured Posts

  • background | Latest projects

    Boulder and oak-tree and stone

    A pebble tree for the commune in Amersfoort Today a new group home for people with a mild intellectual disability inaugurated. I've lately been involved (pro deo) in a number of things in the new home, including the stone-tree and the boulder in the garden. The stone-tree was a special project for me,…

    Read more Boulder and oak-tree and stoneTo proceed

  • Restoration

    Pinnacle for a flying buttress of St. Cunera's tower

    Currently, St. Cunera's tower in Rhenen, the Netherlands, is being restored. Much of the old tufa is replaced in Muschelkalk limestone. I carved a number of ornaments on some profiled blocks, before (and in cooperation with) my colleague Jan Tolboom. These pieces were provided by stone masonry Slotboom from Winterswijk. The stonemason has carved all of the profiles and flat parts, I for this…

    Read more Pinnacle for a flying buttress of St. Cunera's towerTo proceed

  • vanH | coat of arms

    Sandstone has arrived

    Very quietly, the sandstone for my next assignment arrived. And it is a beautiful, very fine piece of stone. I intend to carve a round family crest in relief out of it. It's a lively depiction with two griffins as shield bearers, mantling, a hat as a crest and a fairly simple shield. I did though…

    Read more Sandstone has arrivedTo proceed

  • Restoration

    Modelling griffin in clay and plaster

    Continue with the great griffin. It is a project with long interruptions, because there's always work coming in between that seems to be much more pressing. But last summer there was a holiday period in which Jelle and I could get to work to finally shape the large mirrored griffins. In my last post on this, of…

    Read more Modelling griffin in clay and plasterTo proceed

  • Eusebius | Restoration

    The Man calling Noah (flying buttress figurine)

    Noah's Caller The following flying buttress statue for the Eusebius Church in Arnhem is one of the better known: The Man calling Noah. It's a bald little guy bending over in a highly flexible position and shouting to someone down below. Maybe he shouts that Noah should get along with his boat because the waters are rising? In any case, there is a lot of statue…

    Read more The Man calling Noah (flying buttress figurine)To proceed

Instagram Twitter as well YouTube

© 2026 Sculptor Koen van Velzen
Hosting & Web design Webdiensten ZZP

Scroll up
  • Home
  • About the Sculpture Workshop
  • About Koen
  • Posts overview
  • Projects
  • Videos
  • Contact
Search