Out of a block of black granite, that I had lying around as a remaining piece from a smaller panipitha in black granite, I played a big Shiva lingam with my saw. The material is very tough and difficult to work because it is very dense and fragments in a glass-like way . But the result speaks for itself.
When Shiva lingam and the upper part of the panipitha finished I both due by slings with duct tape to secure the round shape. It is otherwise nearly impossible to hoist. (see also the photos of the final placement)
Nasty the first message about this project.
On to the next post about this project.
From a number of blocks of granite I started carving a large lingam and yoni (panipitha) from the beginning. Below the course of the process of the upper part of the panipitha.
A block of granite (no idea what kind, but it is yellow-pink-brownish and quite big) of 120 x 120 x 45 cms I had intended for the upper part. If I had to order the stone I would have taken a different size, but this is simply what I had lying around.
The block is way too large for presawing on my machine, so I had to cut it all with an angle grinder.
First cutting out the general shape of the top, then cut in the recessed shape of the interior and the recess for the lingam. The edge has been made narrower. The general shape of the upper side is now ready. Now the block can be turned. Start shaping the bottom. Lots of cutting work to be done. Most of the mass has now been removed.
I've put the base on it to see where the shape ends. Next, the lotus leaves are carved on.
Nasty the first message about this project
On to the next post about this project
No more messages to show.
No more messages to show.
