Polishing work on the underside has started

To the first post about this project

I made a spout out of a separate piece of granite , that later will be bonded to the rest of the upper part with epoxy adhesive. I matched its design to the rest of the underside, after which the polishing work could start: 10 steps from coarse to fine with diamond pads, from grain 50 to 10.000. A lot of work.
upper part 29upper part 39

upper part 39b

To the next post on this project

Beeldhouwerijblog.nl is the blog of Koen van Velzen, sculptor in stone and bronze. Look up my website as well: beeldhouwerijvanvelzen.nl

Leave a comment

The email address will not be published.