Jesus back into place again

Installing Jesus statueWith a new set of hands and on a new pedestal of the same French limestone the Sacred Heart statue is looking wonderful again. The statue was installed last Friday in a nice place, inside the school where it formerly stood in the basement: College Hageveld in Heemstede.

placement staue of Jesus HageveldThe statue was to be placed in a relatively empty space, where once the altar of the school chapel used to be, when it was still a minor seminary. Getting it there was a tricky job, because we had to overcome a stairway of about 1 metre 60 high. To make it even harder there was also a bridge spanning the stairs, leaving very little height for lifting the statue.

With a batch of pallets, we filled up the stairs, and with an engine hoist we could lift the statue on the pallets. And even upstairs we could make good use of this hoist, to lift the statue onto its new base. The hands were still not in place, that only came after the statue was anchored to the wall and to the pedestal with a solid stainless steel wire end in the back and in the base plate . As I wrote before, I had first carved two hands out of the same limestone, but by accident both middle fingers broke off. Actually a good thing, for this way I found out that this wasn't strong enough. Now the hands are made with special restoration mortar around a solid stainless steel frame. This way, the statue should last for another century.

The staue of Jesus again in a good spot on a new pedestal.

Beeldhouwerijblog.nl is the blog of Koen van Velzen, sculptor in stone and bronze. Look up my website as well: beeldhouwerijvanvelzen.nl

Leave a comment

The email address will not be published.