Panipitha-bonding the spout

To the first post about this project

Of the large granite panipitha all parts are ready now. Because the granite that I had lying around was too small to carve it out 1 of one piece, I had to make the spout from a separate part and bond that perfectly with the rest. It is glued with strong epoxy glue , supported by 3 thick stainless steel wire ends of 2 cms thick. Finally also the ugly glue seam had to be neatly finished and the shapes made to match.


upper part 42 upper part 47bovendeel 48aupper part 51

upper part 46 To the next post on this project

Beeldhouwerijblog.nl is the blog of Koen van Velzen, sculptor in stone and bronze. Look up my website as well: beeldhouwerijvanvelzen.nl

Leave a comment

The email address will not be published.